Watch Call Receiver ZJ-41H
€45,00 price is not incl. 19% VAT
- Fashionable watch design
- RF wireless technology
- Million of learning codes pairing
- Vibration/Buzzer prompt
- Low-power indication
- Built-in removable rechargeable battery
- Additional information
- System Setup (Video)
- Compatible Transmitters
Low power indication
If the voltage is lower than 3.3V, the low power indicator will be on, please recharge in time.
Connect the DC5V power supply, the blue indicator will be on, when the charging is finished, the LED indicator will be off.
When the service is finished, press the button “SET/RESET” to cancel the calling information. The receiver goes into standby status.
|Dimensions||5.1 × 4.5 × 1.5 cm|
up to 20 call buttons
Vibration, beep or both
red LED light
Impact-resistant plastic housing
|Signal receiving radius|
at least than 150 meters in an open space
integrated rechargeable battery
37mA±10mA (buzzer mode)/ 75mA±10mA (vibration mode)
at least 48 hours with fully charged battery
Amplitude Modulation (OOK)
-10 – +40 °C
Silicone strap; width: 20 mm, length: 255 mm
|Extent of delivery|
watch receiver, packaging, instructions, stand, power supply
possible with a repeater ZZQ-8
There are a total of 4 channels (for example, for 4 rooms) available. At each channel 5 transmitters can be connected.
Waterproof Call Button YK500-3N with 3 FunctionsMultifunctional waterproof call button. It works with 999 channel receivers, with learning code technology. For food & beverages or help press the button and the waiter receive a messege from the customer and will know were to go.€12,00 price is not incl. 19% VAT
Menu Card Holder with Stand€7,50 price is not incl. 19% VAT
Repeater ZZQ-8AUsed to increase the coverage area of the staff calling system. Recommended for use in premises with a lot of artificial barriers (partitions), or if there are several floors in the building.Repeater is a TX/RX device repeating the RF signal. The RF signal should be:€85,00 price is not incl. 19% VAT
- Same frequency to the repeater.
- Oscillating resistor should be matched with repeater.
Smart Remote ControlThis device is used as a remote control for ZJ-46(S), ZJ-49PC. Just as a transmitter with multifunctional buttons for ZJ-22C.€13,00 price is not incl. 19% VAT
How to pair the management remote controller?Press the remote controller to number 000